![connect suzuki df140 to nmea 2000 network connect suzuki df140 to nmea 2000 network](https://i.ytimg.com/vi/542KBgilO-o/hqdefault.jpg)
- #CONNECT SUZUKI DF140 TO NMEA 2000 NETWORK HOW TO#
- #CONNECT SUZUKI DF140 TO NMEA 2000 NETWORK INSTALL#
When connecting the Suzuki engine interface on the DF300 it is not necessary to use the 2 pin trim connection. 2ģ Network connection Interface connection DF300 Single Interface adapter harness with network power connection Interface connection to instrument network through adapter harness The DF300 interface adapter harness is available in single, dual and triple configurations. Make sure there is enough slack in the cable to allow the engine to freely move up, down and side to side. CAUTION When installing this sensor, make sure its cable will not come in contact with any moving parts or parts of the engine that will get hot. On the DF300, you must use the Interface Adapter Harness to connect your interface into the instrument network connection at the main station harness (main helm location).
#CONNECT SUZUKI DF140 TO NMEA 2000 NETWORK INSTALL#
Installation Install one Engine Interface sensor per engine in all applications. For complete instructions on setting up a new NMEA 2000 network or expanding an existing one, see the NMEA 2000 Network Installation Instructions packed with your Suzuki Engine Interface. NOTE: All connectors used to add an engine interface to a NMEA 2000 network will be black Devicenet connectors as shown above. The photo above includes a 2 foot extension cable, T connector, 120- ohm male terminator and 120-ohm female terminator. Tools and Supplies A T connector is the only electronic component needed to attach it to an existing NMEA 2000 network. It MUST be connected to a NMEA 2000 network or it WILL NOT function. The Engine Interface is designed only for use with a NMEA 2000 Network. The sensor converts engine information into a format compatible with the NMEA 2000 data format. 1Ģ This sensor consists of a smart module, black cable connector, Engine Interface connector and Engine Trim connector. See our web site for the latest product status information. All Suzuki NMEA 2000-capable devices are either NMEA certified or certification is pending. You should decide where to install all components before drilling any holes. Read all of the installation instructions before proceeding. CAUTION Installing SMIS network devices is significantly different from installing components without NMEA 2000 features.
![connect suzuki df140 to nmea 2000 network connect suzuki df140 to nmea 2000 network](https://i.ytimg.com/vi/U4jAxINtF5w/sddefault.jpg)
You must refer to your digital gauge, sonar or GPS unit's manual for sensor operation instructions.
#CONNECT SUZUKI DF140 TO NMEA 2000 NETWORK HOW TO#
1 C Suzuki Engine Interface Sensor Installation Instructions This instruction sheet tells how to install your Suzuki Engine Interface and connect it to a NMEA 2000 network using SMIS (Suzuki Modular Instrument System) network components.